Table of Contents
Advertisement
3 = Port No.
By default the Port No. programmed in option 56.4.2.2 will be displayed. To program a new port
number use the B key to erase any existing programming and enter the new port number. Press
the ent key to save the new address and return to the previous menu.
2 = NOT USED
2 = Primary IP
The Primary IP defines the receiver destination details for the primary alarm transmission path. The
destination is made up of an IP address and a port number. To program the IP address press ent. If
groups are enabled the information programmed for the primary IP and port numbers is automatically
copied to all groups.
1 = IP Address
Enter the IP address of the primary receiver. The address will be in the form XXX.XXX.XXX.XXX.
The dot separator will be automatically added after each sequence of three numbers or can be
manually added by pressing the * key. To save the address and return to the previous menu level
press ent. To program the port number of the primary destination receiver press either 2 or A, then
press ent. Note: This number must be programmed, even if groups have been enabled and all groups
have a programmed IP address. This is the IP address used for all system wide events.
2 = Port No.
To erase any previously programmed numbers press the B key. Enter the port number of the
primary destination receiver. The default value is 10002. Press ent to save the programmed
number.
3 = Secondary IP
The Ethernet module supports signaling to more than one receiver destination. The Secondary IP
defines the receiver destination details for the secondary alarm transmission path. The destination
is made up of an IP address and a port number. To program the IP address press ent.
1 = IP Addresss
Enter the IP address of the secondary receiver. The address will be in the form
XXX.XXX.XXX.XXX. The dot separator will be automatically added after each sequence of three
numbers or can be manually added by pressing the * key. To save the address and return to the
previous menu level press ent. To program the port number of the secondary destination
receiver press either 2 or A, then press ent.
2 = Port No.
To erase any previously programmed numbers press the B key. Enter the port number of the
secondary destination receiver. The default value is 10002. Press ent to save the programmed
number.
4 = Account No.
The account number identifies the GX-Series system to the receiver when signals are transmitted.
Every signal transmitted contains the account number. The account number should be between 4
and 6 digits long. After entering the account number press ent to save and return to the previous
menu level. If groups are enabled the account number entered in this field is automatically copied to
all groups.
5 = Receiver
This option determines the paths, which will be used for alarm signaling.
1 = Single
If selected the Primary IP destination and/or specific group IP programming is used to signal
alarms. If 1=Single is selected and a Secondary IP is programmed the Secondary IP destination
will be used in the event of a failure to the Primary IP. A Fail to Comm will be logged against
the Primary alarm transmission path.
2 = Dual
If selected and if a secondary IP is programmed events are sent to both the primary and
secondary IP destinations.
GX-Series Control Panel Installation and Setup Guide
6-97
Advertisement
Table of Contents
