Honeywell GX-Series Installation And Setup Manual page 69

GX-Series Control Panel Installation and Setup Guide
STANDARD USER ACCESS
1 = Modify PIN
The PIN identifies each user to the GX-Series panel and permits the user to operate the system. The
Modify PIN option allows a PIN to be assigned to the user or an existing PIN to be modified. The PIN
must be a four, five or six digit number that is unique to the system.
NOTE: PIN size is dependent upon programming of parameter 51.66=Min Pin Size.
If a duplicate PIN is assigned, the message DUPLICATE ENTRY is displayed; the PIN is not assigned
to the user. As each digit is entered it appears on the lower line of the display. Pressing the * key erases
the last digit displayed; continued pressing of the * key will erase all of the digits. When the correct PIN
has been assigned press the ent key to accept the programming. If a MAX/No. has been previously
assigned the display will prompt: delete max no. A = YES, B = NO and return to the previous menu
level. When a PIN has been assigned to a user number, a solid box (n) is displayed on the top line of the
user number details screen.
AUTHORIZED MANAGER ACCESS
Deleting a PIN
Existing PIN entries can be completely erased by using the * key instead of a digit entry. When there is
no PIN assigned to a user number a hollow square ( ) is displayed on the top line of the user number
details screen.
Assigning Dual Codes
To program a user code as a Dual Code, press the # key while the Modify PIN option is selected. The #
displays at the start of the assigned user PIN (#1314). When a PIN has been assigned as a dual code two
solid boxes (■■) are displayed on the top line of the user number details screen.
NOTE: The Master Manager code can not be assigned as dual.
Dual Codes Operation
Entry of a single dual code can not gain access to the menu, set (arm) or unset (disarm) the system. The
message NO ACCESS – ADDITIONAL CODE is displayed. A second dual code must be entered within
60 seconds of the first dual code to access the menu, set (arm) or unset (disarm) the system. Dual codes
can be different types, the highest type entered is granted access to the system — whether it is entered
first or second.
A single entry of a dual code - without a second dual code entry within 60 seconds - is recorded in the
event log as an Illegal Code; all outputs programmed as Illegal Code are activated.
Dual Focus
If a MAX (proximity card) number for the same user has a # assigned the dual function only works
between the PIN and the proximity card of the same user.
2=Modify Level
Each user is assigned an access level which determines the menu options available to the user. The
programmable levels are from 1.0 - 2.5.
3.6 is assigned to the manager.
3.7 is assigned to the engineer — this is fixed and cannot be assigned to user codes.
3.8 is assigned to the remote code. This is fixed and cannot be assigned to the engineer or user codes.
The remote code can only be used via the remote servicing software.
On selecting this option, enter the level to be assigned to the user and press the ent key to accept the
programming and return to the previous menu level.
6-23