Table of Contents
Advertisement
GX-Series Control Panel Installation and Setup Guide
Keypad Operation
Number Keys
2
3
1
4
5
6
7
8
9
0
GX-033-V0
The number keys are also used, once access to the system has been gained, to select and modify options.
View Keys
A
B
GX-034-V0
Enter Key
ent
GX-035-V0
Escape Key
esc
GX-036-V0
Pound Key
GX-037-V0
Star Key
GX-038-V0
The number keys are used to enter the Personal Identification Number
(PIN) which identifies users to the GX-Series and permits access to the
system options. The PIN Code is a 5 or 6 digit number.
Engineer (Installer)
Remote User
Master Manager
These keys are used to initiate GX-Series system setting (arming). Pressing the A> or
<B key immediately after a valid PIN has been entered starts one of the routines for
setting (arming) the system. The A> key initiates the full setting (arming) routine. The <B
key starts the part setting (arming) routine.
Once the system has been successfully accessed the A> key can be used to step
forward through the GX-Series menu options and the <B key to step backward.
The A> and <B keys can also be re-programmed for different functions.
The ent key is used to:
•
Access the menu options
•
Confirm the programming selections
The esc key cancels any modification made to the current option and returns to the
previous option level. Successive pressing of this key returns the user to the banner
display.
The esc key also aborts the setting (arming) routine if pressed during the exit time.
The # key is used:
•
as a toggle key, which enables or disables the programming features of the GX-
Series options [for example, enabling the OMIT (Bypass) attribute of a zone];
•
to give additional information on the programming options [for example pressing
the # key while in option 22=DISPLAY LOG shows details of the user number,
descriptor and keypad used to cancel alarms or unset (disarm) the system];
•
to activate the Duress and PA outputs; enter a valid user code followed by two
presses of the # key, then the ent key to activate the duress alarm.
The * key is used:
•
to correct or erase PINs in the CODES option and alpha-numeric descriptors in the
TEXT option;
•
to start printing from the current event when viewing option 22=DISPLAY LOG;
•
to display the set (armed) status of the groups.
When Show Status (refer to option 58.6=KEYPADS.Show Status) is enabled, pressing
the * and # keys simultaneously when the normal banner is displayed indicates the
group set (arm) status.
R = Ready to Set (Arm) [all active zones in group closed]
F = Faulted [at least one of the active zones in the group is open]
S = Set (Arm)
P = Part Set (Part Arm)
L = Locked Out
- = Group not assigned to keypad
Note: The Show Status indicates the set (armed) conditions of groups when the
system is set (armed) [keypad blank] or unset (disarmed) [normal banner]. Show
Status does not operate while engineer mode is accessed.
Pressing the * and # keys again toggles the display to show the status of the groups
individually. To move between each group, press the * and A> or the * and <B keys
simultaneously. Pressing the * and # again returns the keypad to the banner display.
Default Code
112233
543210
12345
Table 4-3. Default Codes
4-4
Advertisement
Table of Contents
