Honeywell GX-Series Installation And Setup Manual page 199

Gx series;
Table of Contents

Advertisement

KEYPAD TEXT
TAG REJECT GRP
Rejected card - group set
SET
TAG REJECT ILL
Rejected card - illegal time
TIME
+TAMP C/V
constant Voltage tamper event
+TAMP O/C
Zone changing to Tamper Open Circuit (greater than 12,000 Ohm).
–TAMP O/C
Zone changing from Tamper Open Circuit to Normal Closed (1200 to 900 Ohm).
TAMP RST
Tamper Reset of the system has occurred.
+TAMP S/C
Zone changing to Tamper Short Circuit (less than 800 Ohm).
–TAMP S/C
Zone changing from Tamper Short Circuit (less than 800 Ohm). to Normal
Closed (900 to 1200 Ohm).
+TAMPER
Tamper on a module activated (opened). A module is either a keypad, GX RIO,
Telecom Module or RS232 Module.
–TAMPER
Tamper on a module de-activated (closed). A module is either a keypad, GX
RIO, Telecom Module or RS232 Module.
TEST O/P
Test Outputs menu (Menu Option 32) has been accessed.
TIMEOUT
Timeout alarm after the Entry Time has expired.
+TIMER A
Timer A activated (on).
–TIMER A
Timer A de-activated (off).
+TIMER B
Timer B activated (on).
–TIMER B
Timer B de-activated (off). None
T/O-BURGL
Timeout alarm after the Entry Time has expired (same as TIMEOUT but used as
a SIA event).
U/S EARLY
The Unset Early output has been activated before programmed time.
UNSET
Unset of the system or Group(s).
URGENT
Urgent zone activated.
VIBRATION
Vibration zone activated.
VIDEO
Video zone activated (opened).
VID EXIT
Video Exit zone activated (opened).
+WALK TEST
Walk Test has occurred.
–WALK TEST
Walk Test has finished.
WALL TAMP
Wall Tamper zone alarm.
WRONG CD
Wrong Code alarm activation (6 consecutive wrong codes). This Requires a
system reset.
24 HOURS
24 Hours zone activated (opened).
NOTES: M = Mandatory.
NM = Non-Mandatory
A plus (+) means an event has started. A negative (-) means an event has finished.
GX-Series Control Panel Installation and Setup Guide
DESCRIPTION
D-5
TRIGGER
EVENT
9. Tamper
M
9. Tamper
M
9. Tamper
M
18. Zone restoral
9. Tamper
NM
9. Tamper
M
9. Tamper
M
18. Zone restoral
9. Tamper
M
9. Tamper
M
18. Zone restoral
None
NM
10. Setting
M
None
NM
None
NM
None
NM
NM
2. Intruder
M
10. Setting
NM
10. Setting
M
3. 24 Hours
M
2. Intruder
NM
16. Log Zone
2. Intruder
M
2. Intruder
M
14. Menu access
NM
14. Menu access
NM
9. Tamper
M
9. Tamper
M
3. 24 Hours
M

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gx-520Gx-48

Table of Contents