Honeywell GX-Series Installation And Setup Manual page 103

Zone Function
01 Final
02 Exit
03 Intruder
04 24 Hours
05 Security
06 Dual
07 Entry
08 Push Set
09 Keyswitch
10 Secure Final
11 Part Final
12 Part Entry
13 PA
14 PA Silent
15 PA Delay
16 PA Delay Silent
17 Link
18 Spare
19 Fire
20 Tamper
21 Bell Tamper
22 Beam Pair
23 Battery Low
24 Line Fail
25 AC Fail
26 Log
01 Final {Not for UL installations}
Zones programmed as Final initiate the unsetting (disarming) procedure and terminate setting (arming)
procedure; opening the Final zone when the system or group is set (armed) starts the entry timer; opening
and then closing the Final zone during the exit procedure sets the system or assigned groups, providing all
the zones are closed. The opening (+) and closing (–) of Final zones during the setting (arming) and
unsetting (disarming) procedures are recorded in the event log. Pressing the * key when programming a
Final zone doubles the entry time of the group.
Opening a Final zone during the exit time is reported on the keypad as an open zone; the Entry/Exit
Horns bleep rapidly to indicate that the zone is open.
NOTE: The termination feature of a Final zone can be extended to terminate the setting (arming) of multiple
groups by pressing the * key when assigning a group to the zone. Refer to the Star * Group Function.
02 Exit
Zones that protect the entry and exit routes are programmed as Exit. During the setting (arming) and
unsetting (disarming) procedures Exit zones have a non-alarm operation. If the Exit zone is activated while
the system is set (armed) - without the unsetting (disarming) of the group being initiated - an Intruder
alarm condition is activated.
Opening an Exit zone during the exit time is reported on the keypad as an open zone; the Entry/Exit
Horns bleep rapidly to indicate that the zone is open.
NOTE: The Exit zone can be assigned to multiple groups by pressing the * key when assigning a group to the
zone. This allows an Exit zone to be activated in a group which is not currently being unset (disarmed)
without activating an Intruder alarm. Refer to the Star * Group Function.
GX-Series Control Panel Installation and Setup Guide
Table 6-16. Available Zone Functions
6-57
Zone Function
27 Remote Access
28 Video
29 Video Exit
30 Intruder Delay
31 Log Delay
32 Set Log
33 Custom-A
34 Custom-B
35 Exitguard
36 Mask
37 Urgent
38 PA Unset
39 Keyswitch Reset
40 Bell Fail
41 Intr Low
42 Intr High
43 PSU Fault
44 Not Used
45 Not Used
46 Not Used
47 Vibration
48 ATM-1
49 ATM-2
50 ATM-3
51 ATM-4
52 Alarm Extend