Table of Contents
Advertisement
GX-Series Control Panel Installation and Setup Guide
Pressing the # key while viewing the log can reveal additional information about certain event types:
•
User events reveal the keypad, user type and user group involved in the event;
•
Alarm events reveal the zone descriptor, if programmed.
•
REM CALL event displays the Remote Station ID for the Remote Servicing Software which has
made the connection with the panel.
NOTES: 1. Where two identical events occur within 1 second, only one is logged.
2. Only the first occurrences of high resistance and low resistance events on each day are logged.
Subsequent activations are ignored until midnight of the same day. This is to prevent the log from
being filled with high and low resistance activations from a faulty zone.
The event log can be printed while accessing the Display Log option. Pressing the * key while displaying an
event starts the printout from the displayed event and prints forward to the most recent event. The esc key
aborts the print out.
NOTE: A serial printer must be connected to the GX-Series panel via a printer interface module, the RS232
interface module, or the RS232 serial port.
Option 23 – System
This option provides a quick overview of the system configuration; two lines of information are displayed at a
time - the A> and <B keys are used to scroll through the entire list:
•
Groups
•
Group status
NOTE: Enabling the Show Status option (refer to option 58 = KEYPADS) allows the group set (armed) status to
be displayed from the normal banner [when the system is set (armed) or unset (disarmed)] by pressing
the * and # keys simultaneously.
•
Type
•
Version
•
RIOs
•
Codes
•
Keypads installed 1-8 (GX-48), 1–32 (GX-520)
•
Comms modules 1-7 (Telecom, RS232, ISDN, Ethernet, Int Telecom, Int RS232);
•
Printer
•
DCM Modules
•
MUX Modules
•
Panel location
Option 24 – Print [Quick Menu Option 5]
NOTE: A serial printer must be connected to the GX-Series panel via an on-board RS232 serial port.
This option has two sub-menus:
1 = Printer Module
2 = INT RS232 1
Each of these two sub-menus allows one of the four listed options below to be printed. Only information
corresponding to the groups assigned to the user is printed.
K = KEYPAD
AB LINE
KEYPAD ADDRESS
use the A> and <B keys to scroll through groups A1–8, B1–8, C1–8 and D1–8
U = Unset (disarm), S = Set (arm), P = Part set (Part arm) and L = Locked-out for
each of the groups displayed;
GX-48 or GX-520
version of software in GX-Series panel;
installed includes the on-board RIOs;
used includes the manager, engineer and remote codes;
0–1 (Printer Interface Module);
gives the number of Door Control Modules on the system;
gives the number of MUX Modules on the system
up to 16 characters of text entered in System Text parameter (option 51.15.2).
0:24 SUN 0
JAN
K 0
L7
LEVEL OF USER CODE
6-14
GX-097-V0
Advertisement
Table of Contents
