Fold Angle Adjustment - Konica Minolta bizhub C650 Service Manual

8. Mechanical adjustment
8. Mechanical adjustment
8.1

Fold Angle Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When the crease unit has been replaced.
• When a slant occurs in the crease.
1. Make a copy in the crease mode. (A3 size)
Exit direction
[1]
34
2. Fold the output paper along the
A
3. Fold the output paper and half and
Center
4. If the fold position is slanted as
[1]
4511F3C501DA
5. Open the front door, loosen the
• If the fold position is slanted opposite
6. Make another copy and check the
4511F3C532DA
Field Service Ver. 2.0 Aug. 2007
crease [1].
measure the width A of the paper.
Specification: 0 ± 1.5 mm
shown on the left, make the following
adjustment.
adjustment screw [1], and move the
crease unit to the left to make the
adjustment.
Graduated in 1-mm divisions
to the figure of step 4, move the
crease unit to the right to make the
adjustment.
fold position.