Center Staple Position Adjustment - Konica Minolta bizhub C650 Service Manual

7. Finisher operations
7.4

Center Staple Position Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When staple unit has been replaced.
• When center staple position is misaligned.
• When center staple angle adjustment has been made.
Exit direction
5. Display the Service Mode screen.
See P.434 of the main body service manual.
6. Touch [Finisher].
7. Touch [CB-FN adjustment].
8. Touch [Fold & Staple Pos.Adjustment].
9. Touch [Center Staple Position].
10. Touch [A3] and then touch [Normal Paper].
32
A
4511F3C510DA
Field Service Ver. 2.0 Aug. 2007
1. Load a five-page A4 document in the
document feed tray.
2. Select the center staple mode and
make a copy. (A3 Size)
3. Check the staple position for devia-
tion from the crease (Measure width
A).
Specification: 0 ± 1.5 mm
4. When the width A does not fall within
the specified value, conduct the fol-
lowing adjustment.
4511F3E535DA