6. Sensor check
6.
Sensor check
6.1
Check procedure
• To allow sensors to be checked for operation easily and safely, data applied to the IC on
the board can be checked on the panel with the main unit in the standby state (including
a misfeed, malfunction, and closure failure condition).
A. Procedure
1. Display the Service Mode screen.
See P.434 of the main body service manual.
2. Touch [State Confirmation].
3. Touch [Sensor Check].
4. Touch nine times [ ].
6.2
Sensor check list
6.2.1
Sensor check screen
• This is only typical screen which may be different from what are shown on each individ-
ual main unit.
26
Field Service Ver. 2.0 Aug. 2007
4510F3E515DA