Finisher Check Modes - Konica Minolta bizhub C650 Service Manual

Field Service Ver. 2.0 Aug. 2007
7.2

Finisher Check modes

A. Creasing unit movement mode
• Performs the creasing drive once.
→ Raises the layable guide.
→ Stops after the predetermined time.
→ Lowers the layable guide.
→ The operation is finished.
B. Saddle Unit exit open/close mode
• Opens the saddle exit after the saddle exit is opened and closed.
→ Stops after the predetermined time.
→ The saddle exit closes.
→ The saddle in & out guide advances.
→ Stops after the predetermined time.
→ The saddle in & out guide retracts.
→ The operation is finished.
C. Transport drive mode
• Transport drive is performed for the predetermined time. (Performs the same transport
drive as the pre-drive with the high speed of the connected copier.)
→ Drives the entrance motor (M1).
→ Drives the transport motor/1 (M2).
→ Drives the transport motor/2 (M3).
→ Drives the exit motor (M4).
→ The operation is finished.
• If the mail bin kit MT-502 is installed, the mail bins are also driven.
• If the saddle kit SD-505 is also installed, the saddle transport motor (M8) is also driven.
7. Finisher operations
29