Husqvarna 2011 TE 630 Workshop Manual page 169

Finally, join the parts using a press.
Make sure the pin does not protrude at either ends as you join the flywheel
halves. Observe mounting dimension "A" and set crank pin (1) at distance "B"
on the right flywheel half.
A = 6.35 - 64.45 mm
(2.574-2.578 in.)
B = 0.9 - 1.1 mm
(0.036 - 0.044 in.)
Measure axial clearance "D" of connecting rod to flywheels; it should be 0.45-0.7
mm (0.018-0.03 in.).
Measure crankshaft runout at the bearing locations "C". Runout must not exceed
0.03 mm (0.0012 in).
Straighten the crankshaft using a copper hammer.
Part. N. 8000 H2051 (02-2010)
ENGINE REASSEMBLY
H.13