Cylinder Head Installation - Husqvarna 2011 TE 630 Workshop Manual

ENGINE REASSEMBLY

Cylinder head installation

For valve installation instructions, please see Section "G".
Always use a new head gasket on assembly: see the "Cylinder head gasket
selection table".
Install the head (1) while supporting the timing chain (2) with a tool. Tighten the
head bolts (3) gradually in a cross pattern to 38 Nm+90°; 3.8 Kgm+90°; 28.03
+90° ft/lb (using a 10 mm Allen wrench).
Tighten the two head to cylinder nuts (4) at the sides with a 13 mm wrench (see
Section "X" for tightening torque figures).
Refit the cooling water temperature sensor (4A) using a 17 mm ring wrench; 15
Nm; 1.5 Kgm; 11.6 ft/lb).
Tighten the two head to cylinder bolts (5) with an 8 mm wrench (see Section "X"
for tightening torque figures).
H.36 Part. N. 8000 H2051 (02-2010)