Cylinder Head Gasket Selection Table - Husqvarna 2011 TE 630 Workshop Manual

Fit screws and spacers (13) to temporarily secure the cylinder liner (7).
(2 spacers)
Use a 10 mm Allen wrench; 25 Nm; 2.5 Kgm; 18.44 ft/lb.
Make sure that the piston is at Top Dead Centre.
Measure distance "A" on the two machined faces "B" of the piston and choose
the appropriate head gasket according to the table.
Remove spacers and screws (13) and fit the appropriate head gasket.

Cylinder head gasket selection table

Bring piston to T.D.C. at the end of the compression stroke, measure distance "A"
between piston crown and head gasket mating face and select the appropriate
gasket according to the table below.
CONDITION (see diagram)
1) (piston lower than cylinder mating face)
1) (piston lower than cylinder mating face)
1) (piston lower than cylinder mating face)
Part. N. 8000 H2051 (02-2010)
ENGINE REASSEMBLY
"A" Gasket thickness
-0.5 ± 0.05 mm
-0.6 ± 0.05 mm
-0.4 ± 0.05 mm
H.35
Gasket part no.
1.1 mm
1 mm
1.2 mm
8A00 H0937
8B00 H0937
8000 H0937