Husqvarna 2011 TE 630 Workshop Manual page 321

REAR SUSPENSION
Prise out the retaining ring using two small screwdrivers. Take care not to da-
mage the inner surface.
To remove the retaining ring, first prise one end of the ring out of its groove. Then
slide out the other end, slip the tip of a screwdriver between ring and reservoir
and prise off with the other screwdriver. Take out the retaining ring. Check the
grooves in reservoir body for burrs. If any burrs are detected, they must be
removed and the grooves must be reconditioned.
Screw a pipe with inner thread onto the cap and extract the cap using pliers.
Part. N. 8000 H2051 (02-2010)
J.8