Husqvarna 2011 TE 630 Workshop Manual page 425

FUEL INJECTION SYSTEM
Operation Manual for "DIAGNOSTIC TOOL SOFTWARE KIT" for fuel in-
jection system.
The fuel injection system does not require scheduled maintenance. The
DIAGNOSTIC TOOL SOFTWARE KIT part no. 8A00 A9634 lets you test system
components in the event of a malfunction. A malfunction is indicated by the word
"FAIL" appearing in the right-hand portion of the dashboard display when the
ignition key is set to ON and the right switch is set to RUN.
The DIAGNOSTIC TOOL SOFTWARE KIT (A) is composed of:
- "Diagnostic Tool" Software CD-ROM, including User Guide (PDF), Operation
Manual (PDF);
- User Guide hard-copy;
- Operation Manual hard-copy;
- PC cable for connection to electronic control unit (ECU) connector.
After installing the Diagnostic Tool Software according to the instructions provided
in the User Guide, proceed as follows:
- remove the front fairing (1);
- slip off the cap (B) of the ECU interface connector (C);
- connect the Kit cable (D) to the connector (C) and the serial port (E) of your
PC;
- turn the ignition key (F) to ON and set the right switch (G) to RUN;
- start the "Diagnostic Tool" software you have installed and perform the re-
quired tests.
S.4
Part. N. 8000 H2051 (02-2010)