Husqvarna 2011 TE 630 Workshop Manual page 200

ENGINE REASSEMBLY
Fit the freewheel gear (12) to the flywheel (13) and tighten the screws (14) (5
mm Allen wrench) (see Section "X" for tightening torque figures).
Degrease crankshaft taper end and flywheel bore and smear crankshaft taper
end with Loctite 270.
Install flywheel (13) together with drive gear (14).
Fit washer (15) and nut (16) and tighten with a 24 mm wrench; 130 Nm; 13.0 Kgm;
95.89 ft/lb fitting a dummy gear to the crankshaft gears at the opposite end.
H.44 Part. N. 8000 H2051 (02-2010)