Hydraulic Clutch Lever Adjustment And Fluid Level Check - Husqvarna 2011 TE 630 Workshop Manual

SETTINGS AND ADJUSTMENTS

Hydraulic clutch lever adjustment and fluid level check

Free play (A) must be at least 3 mm.
The lever position can be adjusted to suit the rider hand size.
To decrease the lever distance from the handgrip, rotate the adjuster (B)
CLOCKWISE.
To increase the lever distance from the handgrip, rotate the adjuster (B)
COUNTER CLOCKWISE.
Fluid level is checked as follows:
- remove screws (1), cover (2) and rubber diaphragm from the control;
- keep the control cylinder (3) in a horizontal position and make sure that fluid
level has not dropped lower than 4 mm (0.16 in.) below the upper edge (D)
of master cylinder body;
- if needed, top up with the fluid specified in the
TION A.
NEVER use brake fluid.
Refit any parts you have removed.
Periodically check the connecting hose (see "Scheduled Maintenance Chart ");
if hose (C) is worn or cracked, its replacement is advised.
D.16
CAPACITIES TABLE, SEC-
Part. N. 8000 H2051 (02-2010)