Husqvarna 2011 TE 630 Workshop Manual page 346

Fluid level inside the reservoir shall never drop below the minimum
notch during the bleeding procedure.
Brake fluid is corrosive. In the event of contact with eyes, rinse with
abundant water.
Motorcycle handlebar must be turned to the left during the bleeding
procedure. This will keep the master cylinder reservoir higher, making
bleeding easier.
The bleeding procedure does not remove all air from the circuit; any
small amounts of air left in the circuit will disappear after a short period of
usage; this will eliminate the mushy feel of the lever and restore its travel
to proper length.
If brake lever or brake pedal feel mush after a fall or a repair resulting
in loss of braking, bleed the circuit as described above.
Bleed valve tightening torque: 12-16 Nm, 1.2-1.6 Kgm, 8.8-11.8 ft/lb.
Part. N. 8000 H2051 (02-2010)
BRAKES
L.9