Friction plate to clutch housing clearance
Measure clearance "A" between clutch housing (2) and plate (1) with a feeler
gauge and compare measured clearance with the table below.
STANDARD
0.30-0.50 mm
(0.012-0.020 in.)
If measured clearance exceeds the service limit, replace clutch
plates or housing and repeat measurement. If measurement is still
outside the service limit, replace the complete clutch assembly.
Clutch spring
Measure the free length "L" of each spring with a calliper.
New spring L= 41 mm (1.61 in.).
Service limit: 39 mm (1.38 in.).
Change any spring that is outside the service limit.
Part. N. 8000 H2051 (02-2010)
ENGINE OVERHAUL
SERVICE LIMIT
0.6 mm
(0.024 in.)
G.19