Husqvarna 2011 TE 630 Workshop Manual page 429

FUEL INJECTION SYSTEM
Relay test
Remove cover of saddle and utilities as described in "Section E". Remove the
relays (1) located on the utilities holder plate.
A: Set the meter to the "Impedance" scale and check the energiser coil for
proper operation. Reading should be: 80 Ohm (+/- 10%) at 20 °C.
B: Set the meter to "Continuity" mode and check the circuit is open.
C: Feed the coil from a power supply unit with stable 12V output and make sure
that the circuit closes.
S.8
Part. N. 8000 H2051 (02-2010)