Husqvarna 2011 TE 630 Workshop Manual page 188

ENGINE REASSEMBLY
Refit the plates (9) (install a friction plate first and then a steel plate and keep
alternating between friction and steel plates; the last to go in should be a steel
plate). Fit actuator plate (10), thrust bearing (11), thrust washer (12), pressure
plate (13) and springs (14). Tighten the spring screws (15) gradually in a cross
pattern (5 Nm, 0.5 Kgm, 3.6 ft/lb).
H.32 Part. N. 8000 H2051 (02-2010)