GENERAL PROCEDURES
Electronic control unit removal
-
Remove the saddle as described in the relevant paragraph.
-
Raise the electronic control unit (1) with its flexible mount and detach it from
the rear chassis.
-
Disconnect the connector (2).
Voltage regulator removal.
-
Remove saddle, right-hand side panel and air box cover as outlined in the
relevant paragraphs.
-
Loosen the two screws (1), disconnect the connector (2) and remove the
voltage regulator (3).
Ignition coil removal
-
Remove: saddle and fuel tank as described in the relevant paragraphs.
-
Remove the spark plug cap (1).
-
Disconnect the connector (2).
E.24
Part. N. 8000 H2051 (02-2010)