Secondary Drive Chain Removal; Engine Removal - Husqvarna 2011 TE 630 Workshop Manual

GENERAL PROCEDURES

Secondary drive chain removal

The following procedure applies to both O-ring chains and chains without O-
rings:
- Remove: screws (1), sprocket guard (2), clip (3), master link (4) and chain
(5).
NOTE: On assembly, follow the instructions given on the paragraph covering
the chain in Section "D".
4
3

Engine removal

- Remove the saddle as described in the relevant paragraph.
- Remove the side panels as described in the relevant paragraph.
- Remove the fuel tank as described in the relevant paragraph.
- Remove the exhaust system as described in the relevant paragraph.
- Remove the chain as described in the relevant paragraph.
- Drain coolant from the radiators as described in Section "D".
- Remove the air filter as described in the relevant paragraph.
- Remove the throttle body as described in the relevant paragraph.
- Remove the expansion tank as described in the relevant paragraph.
E.32 Part. N. 8000 H2051 (02-2010)