Water Pump Body Removal; Water Pump Disassembly - Husqvarna 2011 TE 630 Workshop Manual

5
1
4
2
ENGINE DISASSEMBLY

Water pump body removal

- Remove head cover, camshafts and chain tensioner as described in the
relevant paragraph.
Loosen the clamp (1) securing the water pump to cylinder head tube (2) and
take the tube out of the head.
Remove the two screws (3) securing pump body (4) to head (8 mm wrench)
3
and remove pump body and timing drive gear (5).
Check the seal (8) for wear on assembly;
replace if damaged.
H006036

Water pump disassembly

- Loosen the screw (9) with an 8 mm wrench to take pump body apart.
- Loosen the nut (10) to remove the impeller (11).
- Remove shaft (12) to replace bearing (13) and seal (14).
Check the seal (15) for wear on assembly;
replace if damaged.
- Reassemble all parts in the reverse order compared to disassembly and
tighten nut (10) to 4.9 Nm/ 0.5 Kgm/ 3.6 ft/Ib+LOCTITE 648).
12
15
13
14
F.8
11
10
15
9
H006037
Part. N. 8000 H2051 (02-2010)