Right Crankcase Assembly - Husqvarna 2011 TE 630 Workshop Manual

ENGINE REASSEMBLY

Right crankcase assembly

Fit the mesh filter (1) with the perforated end facing outwards.
Fit the two locating bushings (2) into the crankcase.
Refit the gasket (3).
Refit the cover (4) making sure to mate pump shaft (5) with the slotted end (6)
of the output shaft (gently rock the sprocket to facilitate installation).
Tighten the screws (7) in a cross pattern with an 8 wrench (see Section "X" for
tightening torque figures).
Screws (7) are not all the same length; make sure to refit them in their original
positions.
Part. N. 8000 H2051 (02-2010) H.47