Husqvarna 2011 TE 630 Workshop Manual page 207

Part. N. 8000 H2051 (02-2010)
FRONT SUSPENSION
Front fork removal
Measure height "A" (it will need to be restored to original value on assembly). Set
a block under the engine and see that the front wheel is lifted from the ground
and then proceed as follows:
- remove the screws (1) and the brake line clamp (2) on the left-hand side;
- remove the six screws (3) and the fork leg guards (4);
- remove the brake calliper from the L.H. fork leg loosening the two retaining
screws (5);
- remove the front wheel as described in Section "Y";
- loosen the bolts (6) that secure the fork legs to steering head and bottom
yoke;
- remove the fork legs.
Refit the front wheel as described in Section "Y".
Set height "A" back to original value.
Refit the brake calliper tightening the screws (5) to 25.48 - 2.6 Kgm - 18.79
ft/lb and screws (6) to 25 Nm - 2.5 Kgm - 18.50 ft/lb.
I.3