Media Tray Lift Motor - Xerox Phaser 8400 Service Manual

Media Tray Lift Motor

(PL 4.6)
1. Remove the Electronics Module (see page 8-50).
2.
Remove Tray 2.
3. Disconnect the wiring harness from the Media Tray Lift Motor.
4.
From the rear of the printer, inside the cavity, remove the push nut (this is a press
fit).
5.
Remove the gear from the shaft.
6. Remove the two screws holding the Media Tray Lift Motor to the printer frame.
Service Parts Disassembly
s8400-154
8-41