Flash Rom Malfunction - Xerox Phaser 6115MFP Service Manual

Error Codes and Messages
05H Flash ROM Malfunction
Applicable Status Code
Initial Actions
3-12
FLASH ROM will not display or load.
05H:

Flash ROM Malfunction

Check to see if the correct FLASH ROM is installed.
Power down and reboot the system.
Troubleshooting Reference Table
Applicable Parts
Engine Control Board,
PL4.19.15
Warning
To avoid the potential of electric shock, ensure the power to the printer is
off and the power cord is disconnected from the wall outlet prior to
performing Step 3 of the following troubleshooting procedure.
Troubleshooting Procedure Table
Step Action and Questions
1 Check the Engine Control Board
connector P/J702 to the Control Panel.
Is the connection properly seated?
Power up the system.
2
Does the system operate correctly?
3 Replace the board and power up the
system (page 8-57).
Wiring and Plug/Jack References
Print Engine Board Plug/Jack Designators
(page 10-3)
Engine Control Board Locator (page 10-5)
Yes
Go to Step 3.
Complete
Phaser 6115MFP Multifunction Product Service Manual
No
Reconnect and
go to Step 2.
Go to Step 3.