Table of Contents
Advertisement
MUTE GROUP MASTER SWITCHES
The four switches labelled 1-4 activate Mute Groups when pressed.
VCA CONTROL GROUP BEHAVIOUR
Up to 8 VCA Groups can be created. In the normal configuration of the console with a single Output
section block, there are 8 faders available for VCA Masters. Similarly there are 8 assignment LEDs on the
Channel and Output meters.
AUDIO BEHAVIOUR
When a VCA Group has been created, by assigning Input or Output channels to a VCA Master, the following
behaviour is followed:
* The Master fader setting applies its dB value as an offset to all member channels. The
member channels' fader positions remain unchanged.
* If a channel is assigned to more than one VCA Group, the resultant offset applied to the
channel is calculated as the arithmetic sum of the dB values of each VCA Master fader. Any
Master fader reaching –inf dB will set all member channels to –inf dB, regardless of other Master
fader settings. The maximum gain applied to a member channel as the result of the channel
fader setting plus offsets from VCA Master faders is limited to +10dB.
* The [ON]/Off switch on the VCA Master fader acts as a remote control for all member
channels' On/Off switches. If a channel which was previously ON is turned OFF by the action of
a VCA Master On/Off switch, the channel's ON switch will illuminate in RED to distinguish this
condition from a manually OFF channel.
The VCA Master On/Off switch itself has only 2 states, and always illuminates RED when OFF,
Green when ON. (There is no non-illuminated condition). This is because VCA Master On/Offs
cannot themselves be remotely muted, so the Red helps to identify 'Muted' VCA masters.
* The [SOLO/SEL] switch on the VCA Master fader acts as a remote control for all member
channels' Solo switches. The channel 'Sel' function is not activated however.
Page 9 - 2
Soundcraft Vi1™ User Guide Issue 0810
Advertisement
Table of Contents
