Table of Contents
Advertisement
OUTPUTS
Bus Masters can be accessed in any of three ways, depending what is convenient for the way the desk is
being used: with the master fader strips in the Control Bay area; with the encoders in the VST Master area;
or with the BUSSES 1-16 and BUSSES 17-24 layers on the Input Bays.
Master Fader section
There are 6 layers for the master bay: VCA and A to E. They map the following master faders to the master
bay as follows: VCA maps VCA 1-8, A maps busses 1-8, B maps busses 9-16, and C maps busses 17-24.
Layers D and E are normally unassigned, and can be setup like the input layers, to show whatever the
engineer chooses from the output busses available. In fact, layers A, B and C can also be user-customised
to show priority busses.
In the factory-default Front-Of-House Show, busses 1-8 are set as Aux, busses 9-16 are set as Groups,
and busses 17-24 are set to Matrix. If the layer configuration is changed, the new setup can be saved in
your own show file.
To change the configuration of an output layer, press the SETUP button. The upper left part of the screen
will show which output busses are assigned to each output fader. (see screenshot on next page).
Changing the assignment is done exactly as described for input fader pages (see page 8-2).
Page 8 - 4
Soundcraft Vi1™ User Guide Issue 0610
Advertisement
Table of Contents
