Bus Configuration - SoundCraft Vi1 User Manual

BUS CONFIGURATION

The most important configuration of the Soundcraft Vi1™ is the bus configuration, and this is done using
the [ALL BUSSES] view on the input bays.
The TYPE field can be set to one of three values: AUX, GRP or MTX, the encoder is used to change the Bus
Type. If Aux is selected and if the format field, see below, is set to stereo then the {CHPAN} field enables
the stereo Aux send signal to follow channel pan, rather than have its own pan control.
The FORMAT field (only odd busses) is available for Aux and Grp busses and is accessed by pressing the
FORMAT button on the far right of the screen.
The field can be set to Mono or Stereo. The Encoder changes the setting of the Audio Format field. If the
field is set to stereo the next even numbered bus will not be shown.
In the ALL BUSSES Layer, all 24 Busses are showed from left to right on the four input bays. i.e., Bus 1 is
mapped to the left-most strip, while bus 24 is mapped to the right-most strip of the Control Surface.
The Vi1 supports the following Bus Types:
· AUX
· AUX
· Group Mono
· Group Stereo
· Matrix Mono
Page 3 - 6
Mono
Stereo
Soundcraft Vi1™ User Guide Issue 0810