Table of Contents
Advertisement
HiQNET
HiQNet {ON}
Enables or disales the HiQNet ethernet port on the rear of the control surface.
HiQNet ADDRESS
Allows the HiQNet Address for the console to be edited. Every piece of equipment on a HiQNet network
must have a unique HiQNet address.
IP CONFIG: DHCP or MAN
Set to MAN if you wish to manually set the IP address for the console, or to DHCP if you wish the address
to be assigned automatically by an external DHCP server (e.g. a network switch)
IP ADDRESS and SUBNET MASK
If the IP CONFIG mode has been set to MAN, the IP address and subnet mask controls allow these to be
set for the console. In an ethernet network, every piece of equipment must have a unique IP (Internet Pro-
tocol) address. Devices that need to communicate with each other must be on the same subnet as each
other.
Note: when changing settings on the HiQNet page there will be a delay of up to several seconds before
the change is actioned. This normal, and is due to the configuration time of the internal network interface
hardware.
Soundcraft Vi1™ User Guide Issue 0810
Page 14 - 11
Advertisement
Table of Contents
