Output; Patch A Bus To An Output - SoundCraft Vi1 User Manual

OUTPUT

The Output Patch connects a master or bus out with an output connector or MADI channel. A master or
bus out signal can be patched to several physical outputs at the same time.

Patch a BUS to an OUTPUT

There are two ways to access the Output Patch configuration page. They are summarised on page 10-2.
As an example of one of the two methods proceed as follows:
* Press one of the output fader page keys [A]-[D] on the master bay.
* Ensure that no Setup or Menu pages are open (other than 'MAIN Menu').
* Press the [SOLO/SEL] key for the bus to be assigned to an output (or press the [SEL] key
under the LR C faders to assign any of the three main output busses.
* Press the PAN area on the master section touch screen ( this is in the area that the input
meters were being displayed).
* Press the {BUS OUT} Patch button.
* Select the required output on the touch screen.
* Optionally select additional outputs.
* Leave the Patch page by pressing the OUT Patch button again, or the <EXIT> button on screen.
The second method is to select the [BUSSES 1-16] or [BUSSES 17-24] fader pages and access the PAN
area for the required output directly on the input fader screens.)
HINT: It is possible to select <NONE> to reset the patch.
Location groups (e.g., Stage box, Local I/O, etc) can be changed by directly selecting the alternate groups.
HINT: If you adjust a STEREO Bus the desired patch page can be selected with <LEFT> and
<RIGHT> .
Soundcraft Vi1™ User Guide Issue 0810 Page 10 - 5