Mute & Mute Master Keys - SoundCraft Si Performer User Manual

MUTE & MUTE MASTER KEYS
1
2
NOTE: While in mute setup mode it is possible to clear all slaves to any mute master with
[CLR] + [MUTE MASTER 1-8].
NOTE: While in normal operation you may interrogate the mute assignments to channels and
buses on the current layer by pressing and holding the MUTE key.
NOTE: For any channels or buses muted by a mute master the channel or bus ON key changes
from green to red.
26
1. MUTE key: press this key to toggle in/out of mute setup mode; the
key has no function on its own and requires the selection of one of
the mute masters 1-8 to indicate which of the mute masters you are
going to configure.
2. MUTE MASTERS 1-8: while mute master setup is active these keys
define which mute master you are setting assignments for, when not in
MUTE SETUP the keys act as the mute masters..
SETTING AND USING MUTE MASTERS:
a. Press the MUTE key then one of the MUTE MASTER keys 1-8; SELect
keys will light if any of the channels or buses on the surface is assigned
as a slave to the selected mute master.
b. Add or remove slaves by pressing the SELect keys on the channels or
buses you wish added or removed from the mute master.
c. Press the MUTE key to finish the setup.
d. Active any mute mater(s) by pressing the MUTE MASTER keys.
Soundcraft Si Performer User Guide V1.1 1112