CHANGING OUTPUT BUS PARAMETERS
The following pages shows bus master processing using the Input strip ({BUSSES 1-16] or [BUSSES 17-
24] layer) mode as an example. Parameter changing is done in the same way if either of the other two
ways of accessing bus masters is used.
Changing A Parameter Of A Bus
* Press the desired touch field, the corresponding VST Area will open
* change the parameter
* Press the touch field again to go back to the default VST view
or
* Press another touch field.
The picture shows the relation between touch fields and master functions.
Equaliser
Page 5 - 8
Soundcraft Vi1™ User Guide Isuue 0810