Table of Contents
Advertisement
To make selection of the source and destination units easy, a set of 4 FX-select screens appears on the
upper section of the Vistoonics screen in both Copy and Paste modes. The selection is made by touching
the relevant Vistonics screen section by the FX unit.
Alternatively, if the FX unit is assigned to a channel or bus and is therefore visible on the channel or bus
strip, then the source and destination units can be selected by touching the FX block on the channel strip.
Note that only the parameters relating to the currently active FX Type are copied and pasted for each unit
– so for example if LEX1 is currently set to the Small Hall FX type, then only the Small Hall parameters will
be copied, if LEX1 is selected to copy.
When the settings are pasted to another unit, the target unit will have its FX Type changed to Small Hall,
and only the Small Hall parameters will be pasted. None of the other 28 FX Types within the target FX unit
will have their settings changed.
To copy an FX unit's settings to the clipboard:
.
Press [COPY]
.
Select the required FX Unit, either using the FX Select Encoders displayed in the central
screen, or touching the FX unit's icon on the Channel or Bus strip, if one has been assigned and
is visible on the strip.
Parameters are copied to the clipboard
.
Press [PASTE]
.
Select the destination FX unit by touching the required FX Select Encoder (or adjacent
button) in the central screen.
touching any touch field on the target channel or bus strip.
pressing [SOLO/SEL] on the target channel or bus
The FX unit settings on the clipboard are immediately copied to the destination FX unit.
.
The operation can be undone by pressing [UNDO], before exiting Paste mode.
.
End the function by pressing [PASTE] again.
Soundcraft Vi1™ User Guide Issue 0810
or
or
Page 18 - 5
Advertisement
Table of Contents
