SoundCraft Vi1 User Manual page 82

There are five User Defined pages User 1, 2, 3, 4 and 5 that can be created, and each of these can
contain any combination of the channels that appear on the three Fixed layers. It is also possible to
arrange VCA Master faders within the User-defined Fader pages, along side input channels. There are no
restrictions on how many times you can use a particular channel, so for example it is possible to assign a
vocal channel to the same fader in all five User Pages, meaning that it will appear to remain in the same
place on the surface regardless of which User Page is selected.
To configure a User layer
Press the Setup button in the Input Fader Page control section.
This opens up a setup screen across the Vistonics screens.
Each Setup screen contains five rows of buttons, corresponding to the User Pages 1, 2, 3, 4 and 5 for the
16 fader strips. If you load a Default Show, all of the faders in all of the layers will have a default setting of
NONE, which means that no channels are yet assigned to any of the faders in the User Pages.
To start assigning channels to the fader Strips, touch any of the buttons labeled 'NONE' in the previous
screenshot, corresponding to the position and layer of the fader you want to assign something to. Normally
you would start at the top left and work across each layer, assigning the faders in order.
Touching any of the 'NONE' buttons opens up the 'Channel Select' screen that then allows you to choose
any of the input channels on the desk to be assigned to your chosen fader.
The tabs on the right side of the screen allow all available input channels or the VCA Masters to be
accessed.
Page 8 - 2 Soundcraft Vi1™ User Guide Issue 0610