Table of Contents
Advertisement
INPUT
The Input Patch connects an input connector or MADI channel with the desired input channels.
Each input connector signal can be patched to more than one input channel at the same time.
Input Patch Point can be set individually for both possible Inputs IN1 and IN2, using the IN1 PATCH and
IN2 PATCH configuration button.
IN 2 can optionally be used for the > SPARE MIC function.
The small blue A/B legend in the Channel Label area shows which other channels use the same
signal, where A means this channel on the Input Layer A and B means this channel on the Input
Layer B.
Patch A Source To An Input Channel
* Press the Input field of the desired Channel
* Press the IN1 or IN2 Patch button
* Select the desired Input Source -> Audio will immediately patched
* Leave the Patch page by pressing the IN1 or IN2 Patch button again, or the Exit button on
screen.
HINT: It is possible to select NONE, that means no audio source is patched to this INPUT.
Location groups (e.g., Stage box, Local I/O etc) can be changed by directly selecting the
required group on the right-hand side of the screen.
HINT: If the channel is paired, <LEFT> and <RIGHT> comes up and allows toggling between the
input patch for L & R of the paired channel.
Soundcraft Vi1™ User Guide Issue 0810
Page 10 - 3
Advertisement
Table of Contents
