Table of Contents
Advertisement
COPYING CHANNEL OR BUS PARAMETERS
·
Press [COPY].
[COPY] lights.
·
Collect Channel Parameters by pressing [SOLO/SEL] for the whole Channel
or
Touch Fields for functional groups like EQ
or
Long press on Touch fields to enter Zoom mode for individual Parameters.
Parameters are copied to the clipboard.
·
Press [PASTE].
[PASTE] lights, [COPY] will be switched off.
·
Select the destination channel by pressing [SOLO/SEL]
or
touching any VST field on the channel.
The clipboard content is immediately copied to each selected channel.
·
End the function by pressing [PASTE] again.
The same procedure can be used for busses: you must be in the ALL BUSSES fader page to collect
functional groups or parameters
COPYING A BUS MASTER INCLUDING ALL CHANNEL SEND LEVELS
·
Press [COPY].
[COPY] lights.
·
Select a Bus Master with [SEL]. This can be done either in the central output fader section (pages
A-D), or the ALL BUSSES page.
·
Press [PASTE].
[PASTE] lights, [COPY] will be switched off.
·
Activate "include send levels" in the central page (choose YES).
·
Select the destination Bus with [SEL].
·
End the function by pressing [PASTE].
HINT: Bus copy can be performed between different Bus Types (AUX<>GRP, GRP<>AUX). In this
case the ON/OFF state of the AUX sends will be equivalent to Group Routing ON/OFF.
PARAMETERS NOT INCLUDED IN CHANNEL & BUS COPY MODES
When you copy a whole channel, a whole bus, or the input and output blocks within the channel or bus,
not all parameters are copied. For example if a whole channel is copied, the Input patch, gain, Insert and
direct out settings are NOT copied.
The sections below list the various parameters that are NOT included if the whole channel or bus is se-
lected for Copy using the SEL button.
Note that additional parameters can be added to –or subtracted from- the channel copy by
using the 'long-press' on the touch screen in the required field and then selecting or deselecting
various parameters.
It is never possible to select the Insert point or Direct Out however.
Soundcraft Vi1™ User Guide Issue 0810
Page 18 - 3
Advertisement
Table of Contents
