Monitor Setup Sub-Page; Output Solo Selection - SoundCraft Vi1 User Manual

MONITOR SETUP SUB-PAGE

OUTPUT SOLO SELECTION

Output Solo Selection allows an individual output solo to be sent only to a specific monitor output (Mon A,
B or Phones). This is useful for stage monitoring applications where the solos of in-ear monitor mixes could
be programmed to appear only on Monitor B for example, which could have an in-ear headphone system
connected to it. In this example, conventional wedge monitor mixes could be programmed to appear only
on Monitor A when soloed, where Monitor A could be connected to a wedge speaker system.
OUT SOLO A field
Displays the Busses which are included in the OUT SOLO selection (default ALL) for Monitor A. Its VST
{config button} opens the OUT SOLO Group configuration page.
OUT SOLO B field
Displays the Busses which are included in the OUT SOLO selection (default ALL) for Monitor B. Its {VST
config button} opens the OUT SOLO Group configuration page.
OUT SOLO HP field
Displays the Busses which are included in the OUT SOLO selection (default ALL) for the headphones. Its
{VST config button} opens the OUT SOLO selection configuration page.
Each of the 32 outputs can be switched in or out of the output monitoring group, for each of the 3
monitoring circuits. The <NONE> key deselects all of them. <EXIT> makes the display go back to the
previous page. The selctions made are mirrorred in the small OUT SOLO areas of the VST area. The colours
indicate the type of each output: Aux Group or Matrix.
Page 11 - 8 Soundcraft Vi1™ User Guide Issue 0810