The Master Section - SoundCraft SPIRIT FOLIO User Manual

This is used to set up a separate mono
mix for FOLDBACK or to drive EFFECTS
PROCESSORS, and the combination of
all the Aux 1 Sends is mixed to the Aux 1
Output. For Effects it is useful for this to
fade up and down with the FADER (this is
called POST-FADE), but for Foldback or
Monitor feeds it is important for the send
to be independent of the FADER (this is
called PRE-FADE).
The Master Section AUX1 PRE switch
allows you to chose pre- or post-fade as
required. Leave the knob turned down
when not in use.
See page 13
This control sets the amount of the channel signal feeding the Right and Left MIX
outputs, allowing you to balance the source in the stereo image. When the
control is turned fully right or left you feed only that side of the signal to the mix.
See page 13
The linear FADER gives you smooth control of the overall signal level in
the channel strip, allowing precise balancing of the various source
signals being mixed to the Master Section. It is important that the input
level is set correctly to give maximum travel on the fader. See the `Initial
Setting Up' section on page 10 for help in setting the right level.
See page 13
All manuals and user guides at all-guides.com
When the PFL (Pre-Fade-Listen) switch is pressed a
mono sum of the pre-fade channel signal is fed to the
monitor output or headphones, replacing the normal
source (either Mix or Tape Return).
You use this switch to listen to a channel signal without
affecting the mixer outputs, to check the signal quality
or simply to check that it is there!
See page 13
$