Table of Contents
Advertisement
Detune - Stereo
Detune adds a slightly pitch-shifted version of the original source, thickening the sound. This creates a
particularly effective simulation of "double-tracking. " This effect is also a great alternative to the Chorus
effect, adding the richness of a chorus without the audible sweep caused by the chorus rate. It is also
useful for creating a wide stereo signal from a mono source, by setting a small detune amount up on one
output and down on the other, and panning the two outputs hard left and right.
MODULATED EFFECT CONTROLS
Speed
Sets the speed at which the modulated effect cycles.
Depth
Scales the intensity of the effect. This control affects the output of the LFO only. It has no effect on the
outputs of the individual waveforms.
Voices
Controls the number of additional Chorus voices.
Regen
Controls the amount of modulated signal being fed back into the input, creating feedback. Higher amounts
add more resonance to the signal.
Diffusion
Creates a time-smoothing effect similar to diffusion in reverb. Diffusion can be a subtle effect to add a
little warmth to the chorus.
PreDelay
Determines the amount of offset between the two signals that create the flange effect. Lower values create
a tighter effect, higher values result in a more extreme "whooshing" sound.
Waveform
Selects the wave pattern used by the modulated effect.
Phase
Controls whether amplitude or depth change occurs in both left and right outputs simultaneously or
alternates between left and right outputs.
Phase Stages
Selects between a 4, 8, or 12 state phase shifter.
Stereo Spread
Increases or decreases the stereo imaging of the Rotary effect.
Drive
Provides overdrive gain to the preamp section of the rotary speaker effect.
Minimum Speed
Sets the minimum speed at which the effect will oscillate.
Soundcraft Vi1™ User Guide Issue 0810
Page 20 - 17
Advertisement
Table of Contents
