SoundCraft Vi1 User Manual page 59

PAN
The following table shows the destination level in relation to the PAN settings
MODE Left position
Left
PAN OFF - 3 dB
PAN ON 0 dB
HINT: If the PAN function is switched off, the gain is the same as if you had set the Encoder to the middle
position.
If all TRIM, Faders and so on are in the 0dB position the outputs from the L and the R Masters are 3 dB
lower than a MONO Input signal.
MONO PAN
If a panning mode is set to LCR, then the WIDTH function will become active.
LCR PAN with WIDTH = 0
LCR PAN with WIDTH = 100
Soundcraft Vi1™ User Guide 0810
Middle position
Right Left
- 3 dB - 3 dB
- ∝
- 3 dB
Right position
Right Left
- 3 dB - 3 dB
- ∝
- 3 dB
Right
- 3 dB
0 dB
Page 4 - 17