Cue List Page - Gpio/Misc Field Touched - SoundCraft Vi1 User Manual

CUE LIST PAGE - GPIO/Misc Field Touched

Note: GPIO functionality is only possible on the Vi1 if a stagebox is attached, or a GPIO card is fitted to the
D21m option slot.
GPI {ON} key: Enables/disables reception of the defined GPI signal from recalling the current Cue.
VIRTUAL PIN encoder: Allows a Cue List Virtual GPI Pin to be selected as the trigger source. The Virtual Pin
must be assigned to a real (Physical) Pin in the GPIO Page. The Virtual pin number display is in grey text if
that pin is already used by another Cue.
{STEAL} key: Only displayed if the selected Virtual pin is already assigned to another Cue.
Pressing the STEAL button reassigns the Virtual pin to the current Cue (no warning dialogue given).
PHYSICAL PIN field: displays the physical Pin number that is currently assigned to the selected Virtual Pin.
(Display only). If a physical pin has not been assigned, this field will be empty.
GPO {ON} key, as above, but for outgoing GPO events. The Virtual GPO pins must be set up in the GPIO
page.
There is no need for a Steal key on GPOs, several Cues can be assigned to the same v-pin. Note that
although there is only one v-pin per Cue, a v-pin can be assigned to any number of physical pins in the
GPIO setup page.
HiQnet {ON} key: enables/disables the transmission of the assigned HiQnet Venue Change message upon
recall of this Cue.
HiQnet encoder: Allows selection of the Venue Change number that will be transmitted from the HiQnet
Ethernet port when this Cue is recalled.
Note that the IP address of the console must be set up in order to use the HiQnet functionality. These
parameters are available in the Menu\system\HiQnet page (see chapter 14).
Page 15 - 20 Soundcraft Vi1™ User Guide Issue 0810