Bus Configuration - SoundCraft VI6 User Manual

BUS CONFIGURATION

The most important configuration of the Soundcraft VI6™ is the bus configuration, and this is done using
the [ALL BUSSES] view on the four input bays.
Figure 3-5: The Input Screen If [ALL BUSSES] Layer Is Active.
The TYPE field can be set to one of three values: AUX, GRP or MTX, the encoder is used to change the Bus
Type. If Aux is selected and if the format field, see below, is set to stereo then the {CHPAN} field enables
the stereo Aux send signal to follow channel pan, rather than have its own pan control.
The FORMAT field (only odd busses) is available for Aux and Grp busses. The field can be set to Mono or
Stereo. The Encoder changes the setting of the Audio Format field. If the field is set to stereo the next even
numbered bus will not be shown.
In the ALL BUSSES Layer, all 32 Busses are showed from left to right on the four input bays. i.e., Bus 1 is
mapped to the left-most strip, while bus 32 is mapped to the right-most strip of the Control Surface.
Vi6 supports the following Bus Types:
· AUX Mono
· AUX Stereo
· Group Mono
· Group Stereo
· Matrix Mono
Page 3 - 6 Soundcraft Vi6™ User Guide