5 Maintenance
5.5 Transfer and transportation
This section explains transferring and transporting the printer.
5.5.1 Transferring the printer
The following are instructions for transferring the printer.
CAUTION
• • • •
Keep the printer horizontal during transfer.
• • • •
Do not tilt the printer, stand it against a wall, or turn it upside down. Doing so
may cause ink to leak inside the printer. Also, movement after transport is not
covered by the warranty.
(1) Before the transfer
Follow the steps below to transfer the printer.
1. Make sure that the printer is turned OFF.
2. Dispose of the waste fluid.
3. Remove the 2 scrollers.
4. Disconnect the power cable and all other cables.
5. Turn the 4 adjusters to the directions shown in the diagram to loosen.
6. Transfer the printer.
NOTE
The casters attached to the stand is designed for transferring the printer short distances on a surface in-house.
PJ-1614NXE PJ-2216NXE OPERATION MANUAL
5-22