PJ-1614NXE PJ-2216NXE OPERATION MANUAL
3.4.1 Turning the power ON
p.3-8: Modify the procedures after step 3 as follows:
3. Put the purge plate on the purge stand.
NOTE
NOTE
The purge plate must be placed on the purge stand whenever the power is on, except in the case when
head cleaning is performed (
If waste fluid comes into contact with the inside of the product, the product may malfunction.
When setting the purge plate, make sure not to contact to the print head surface
4. Close the front cover and the maintenance cover.
:
(omitted)
8. After finishing initial setup operations, the product will enter the normal operating condition.
9. Using the attached syringe, soak up the ink collected in the print head cap, then transfer
to the container.
PJ16E-A-00d
4.5.4 Head cleaning)
No.
Purge stand
1
Purge plate
2
1
No.
Print head cap
1
Syringe
2
Name
2
Name
5
ERRATA
April 2002
MUTOH INDUSTRIES LTD.