6.5 TRANSFER AND TRANSPORTATION
This section explains transferring and transporting the printer.
6.5.1 Transferring the printer
The following are instructions for transferring the printer.
(1) Before the transfer
Follow the steps below to transfer the printer.
Step 1 :
Make sure that the printer is turned OFF.
Step 2 :
Dispose of the waste fluid.
Step 3 :
Remove the 2 scrollers.
Step 4 :
Disconnect the power cable and all other cables.
Step 5 :
Turn the 4 adjusters to the directions shown in the diagram to loosen.
Step 6 :
Turn the following adjusters to the directions shown in the diagram to loosen.
Stand : 4
Winding unit: 1
Feed unit : 1
Step 7 :
Transfer the printer.
Notes :
The casters attached to the stand is designed for transferring the printer short distances
on a surface in-house.
Caution :
Keep the printer horizontal during transfer.
Do not tilt the printer, stand it against a wall, or turn it upside down. Doing so may
cause ink to leak inside the printer. Also, movement after transport is not covered by
the warranty.
228
User's Guide – Toucan Hybrid
AP-750, Rev. 1.1 –- 23/04/04