2.7 TRANSFER AND TRANSPORTATION
2.7.1 Transferring the printer
Be sure to read and understand the safety warnings before handling the printer.
(1) Pre-transfer steps
Verify that the printer has been switched OFF.
Step 0 :
Verify that the butterfly bolts attaching the stand with the printer, are not loosened.
Step 0 :
Verify that the printer head is in the rightmost position.
Step 0 :
Attach the protective material (metal plate) for attaching the head unit (1), and fix it with
Step 0 :
thumbscrews (2).
No.
1
2
Remove the scroller.
Step 0 :
Unplug and remove all cables.
Step 0 :
Release the lock of the caster wheels and transfer the printer.
Step 0 :
Notes
•
The casters supplied with the dedicated stand are manufactured for a small transfer on a plain surface.
When moving the printer outdoors, and in places with big step differences, then move the stand and
printer separately. For further details please refer to the Installation guide.
(2) Steps after transfer
Choose a suitable place for installation and place the printer.
Step 0 :
See "Installation guide"
Verify that the butterfly bolts fixing the stand with the printer are not loosened.
Step 0 :
Connect all cables.
Step 0 :
Perform a nozzle check, and verify that there is no clogging in the printer head.
Step 0 :
See "Nozzle check"
Perform a head alignment.
Step 0 :
See "Adjust print"
1
Name
Protective material (metal plate) for attaching the head unit
Thumbscrew
Operation Instructions VJ-1204
2
26
AP-77170, Rev. 2.0, 2/04/2007