Table of Contents
Advertisement
3 Basic Installation
1
No.
1
• The media initial menu is displayed on the control panel.
TIP
•
When changing the media type, follow "3.6.6 Setting media type" .
3.6.5 Setting winding unit
The setup for the winding unit is described below
When using the winding unit, set up the winding unit according to the following procedure.
1. Attach the media tube to the scroller for the winding unit
•
3.6.1 Attaching roll media (PJ-1614NXE)
•
3.6.3 Attaching roll media (PJ-2216NXE)
2. hold the scroller so that the fixed flange is on the right, and attach both ends of the scroller to the
winding unit.
NOTE
•
When attaching the scroller to the product, refer to the following diagram and attach properly.
If the direction of the attachment is wrong, the media will not be wound correctly.
Front cover
PJ-1614NXE PJ-2216NXE OPERATION MANUAL
Name
3-34
Advertisement
Table of Contents
